Vdwall LVP603S User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 23
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
LVP603S User’s Manual
---------------------------------------------------------------------------------------------------
LED VIDEO PROCESSOR
21
10. Factory district setup
The following setups must be made by relevant qualified technicians or
follow the guidance of the plant technician. otherwise the incorrect and
improper operation will result to abnormal situation.
Item 28: Device_Init”
After enter the No.27 Item from the No.26 Item, press “V1” for 5 times
and then press “”move to the No.28 Item: “Device_Init”, click
” or “” to select “Yes”, then click “Enter” to restore to the factory default
setup, and mention “please power off & on again”, and then just follow the
instruction.
Item 29: Bias”
In order to decrease the noise on gray scale display, the LED display
system usually removes the lower gray scale one of all input signals, which will
cause the lose of the video information, especially in dark scene ,such as night
view.
LVP603S can improve problems as follow mentioned by adjusting the
“ Bias”, whose limit ranging from 0 to 32. When losing the signal of dark scene,
you can restore the drop-out information to the LED display by increasing the
value.
Normally in order to keep the completeness of output signals, the
standard value is set as 0!
Item 30: Auto ADC”
After inputting the analog signal to the video processor who’s ADC has
not been revised, the picture on the display may appear some bad phenomena,
such as color cast, extreme-darkness. LVP603S can overcome all of problems
by automatically revising white balance in terms of the input analog signals (AV,
and VGA). Figure below shows the method of “Auto ADC”.
When switched to the corresponding analog input signal, the processor
will receive and output the signal to the LED display, then, get into the No.18
Item, press “ ”or “ ” to select “ Yes”, at last, press “ Enter” to carry on auto
ADC.
Caution: All video processors have gone though the auto ADC, please
use this item delicately!
Page view 20
1 2 ... 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments